Pattern control valves

Quick Change Pattern Control Valve Make life easy for you and your staff!
Select Currency
  • QUICK CHANGE PATTERN CONTROLLER
    Quick Change Control valve with 8 ports to change Pilot Controlled Excavators from any pilot controlled excavator in SECONDS!! All Steel Not aluminium! These are USA made.
    This valve will work on any excavator that is pilot controlled, ( uses low oil pressure to control high pressure hydraulic control valve )
    It comes with instructions as to where to connect hoses and how it works, Changes from ISO to SAE (Hitachi to Cat) with one move of the lever! Change it in less that one minute from the time you leave the seat till you are back in and ready to dig the way it works for you!

    The ports are SAE 04 and you will need to have hydraulic shop supply the fittings and hoses you will need to connect this valve to your system!
    Note: Always install in line between pilot controls (joy stick valve in cab) and junction block behind cab, Never between block and high pressure hydraulic control valve! For Hitachi Excavators ( 120, 120C, 160LC, 160CLC, and many others You will need 8 standard SA
    NZ$ 1,195.00
    NZ$ 1,374.25 incl GST
Quick Change Pattern Control Valve Make life easy for you and your staff!

Make an Enquiry

 

© Copyright Excavator Parts - Site map
Phone: 0275558338 New Zealand

Website Builder - Website World